Browse

Plumbing Tools Safety Tips:

• Always pull rather than push a pipe wrench handle.
• Maintain a gap between the back of the hook jaw and the pipe. This helps maximize gripping force and centers the pressure on the jaw teeth.
• Always wear eye protection.
• Do not use a pipe wrench to bend, lift or raise pipe.
• Do not apply excessive pressure to a pipe cutter, as this could cause the cutting wheel to break.
• Do not use a pipe cutter as a C-clamp.
• Replace worn cutter wheels on pipe cutters.
• Use the proper cutting wheel in the pipe cutter. There are separate wheels available for plastic, cast iron, copper and other materials.
• Always wear eye protection when cutting pipe.
• Do not use a flaring tool for holding pipe.
• Do not thread hardened steel or any pipe bigger than the working diameter of the threader.

Featured Plumbing

FAQ's

Q: Is there a wrench I can use that will not damage the brass, aluminum or other soft material? 
A: Yes, a strap wrench grips the pipe without teeth. 

Q: What does O.D. and I.D. mean? 
A: This refers to the diameter of a pipe. Some pipes are measured based on their outside diameter, or O.D. Others are measured by their interior diameter, or I.D. 

Q: What is the difference between soft copper tubing and hard copper tubing? 
A: Hard copper is rigid line used throughout the house. Soft copper is used where flexibility is needed, such as faucet supply lines.

Q: What is a compression fitting? 
A: This type of fitting squeezes a brass or plastic ring around copper or plastic tubing.

Q: What is a flare fitting? 
A: A connector is slipped over the end of a copper tube, which is then flared out using a special tool. The fitting can then be screwed into another fitting. 

Q: How do I cut copper tubing?
A: You can cut copper pipe with a regular hacksaw or a copper tube cutter. Although both will make a satisfactory cut, the tube cutter ensures a square cut every time.  When cutting pipe for a specific run, be sure to make allowances for the distance of pipe that fits into the fittings. Also, remember to add the extra length the fittings will give the entire run of pipe. Figure about 1/2" for each fitting.

Products you will find in this category are: Pipe Tools, Inspection Tools, Locating Tools, Augers, Drain Machines, Reciprocating Saws, Wrenches And More

Reasons To Shop at ToolsDirect.com

Top Sellers

• • 
  • Ridgid 25643
  • SeeSnake® micro™ Inspection Camera
  • Our Price: $219.91
  • You Save 12%
  • 
• • 
  • Ridgid 66497
  • Hand Tools Drain Rooters
  • Our Price: $1,643.97
  • You Save 12%
  • 
• • 
  • PACE AC-1039
  • Mini-Mite™ Roll Groover
  • Our Price: $669.10
  • 
• • 
  • Ridgid 66807
  • Model 2006 Faucet & Sink Installer
  • Our Price: $20.33
  • You Save 12%
  • 
• • 
  • Ridgid 31090
  • Ridgid 31090 10" Aluminum Straight Pipe Wrench
  • Our Price: $31.99
  • You Save 12%
  • 
• • 
  • Ridgid 23493
  • Single Stroke Plastic Pipe and Tubing Cutter
  • Our Price: $27.68
  • You Save 12%
  •